TranstarManual Transmission
Part #: NV4500-ID $1,671.55 $1,500.00 Core
Call for Availability: +1 (833) 363-1938
Login for personalized shopping
Description & Specs
All units are torn down and thoroughly cleaned. All hard parts are inspected and if a known failure point has been identified, the part is replaced with a remanufactured or new part that is OE-quality or better. All soft parts are replaced. Units are assembled and, when possible, Dyno tested (Software to test some late models units is not yet available).
Manual Transmission; Remanufactured
This Kit Contains
Gasket; PTO Cover × 2
# 301305
Loc. Pin × 1
# 301485
Bearing; Needle, 50mm x 58mm x 20mm × 1
# 303211A
Insert; Mode, Long, 45MM, Reverse Center × 1
# 321700-2A
Gasket; Adaptor to Transfer Case; Round with 6 Holes × 1
# 331304A
Seal; Front × 1
# 334070
Seal × 1
# 334074A
Seal × 1
# 334074C
Seal × 1
# 334076
Seal × 1
# 334076A
Bearing × 1
# 334211-2
Bearing Cup × 1
# 334211-3
Shim Kit; Countershaft × 1
# 334225
Shim Kit; Countershaft × 1
# 334225A
Shim Kit; Countershaft × 1
# 334225B
Shim Kit; Countershaft × 1
# 334225C
Shim; Mainshaft .004"-.005" × 1
# 334226
Shim; Mainshaft .006"-.006" × 1
# 334226A
Shim; Mainshaft .010"-.012" × 1
# 334226B
Needle Bearing; Input × 1
# 334240
Bearing Race; Input × 1
# 334240-3
Pocket Bearing, Input × 1
# 334267
Needle Bearing × 1
# 334271
WASHER, NV4500, 3RD GR × 1
# 334273
Needle Bearing × 1
# 334274
Needle Bearing × 1
# 334275
Needle Bearing; Reverse × 1
# 334277
Reverse Idler Bearing × 1
# 334278A
WASHER, NV4500, REV × 1
# 334290
Back Up Light Switch; Reverse × 1
# 334411
Bearing Cap × 1
# 334483
Gear; 2nd, 37 Teeth × 1
# 334582
3rd Gear Counter Shaft, 30 Tooth, 5.61 Ratio × 1
# 334583-1A
3rd Gear Main Shaft, 29 Tooth, 5.61 Ratio × 1
# 334583A
Gear; Countershaft 4th, 38 Teeth × 1
# 334584-1A
Gear; 5th, 22 Teeth, with 31 Inner Spline × 1
# 334585-2
Clutch Cone; Reverse Gear, For Mainshaft Reverse × 1
# 334587-2
Shifter Assembly × 1
# 334625A
Shifter Spacer Plate × 1
# 334627
Shift Rail; 5th × 1
# 334628
Shift Lug × 1
# 334628-1A
Shift Rail × 1
# 334628A
Shift Rail × 1
# 334628D
Hub and Slider Kit; 3rd-4th × 1
# 334642K
Slider; 5-Reverse × 1
# 334644
Input Shaft; 22 Teeth, 10 Spline × 1
# 334670D
Cone; Input Synchro × 1
# 334701-1A
1-2 Synchronizer × 1
# 334701-3
Synchronizer; 3-4 × 1
# 334703
Synchronizer; 5th × 1
# 334705
Key; For 1-2 × 4
# 334707-1
Key; 3-4 × 3
# 334707-3
Spring; 2-3 Synchro × 3
# 334710-3
Bearing Retainer × 1
# 334724
Detent Plunger × 3
# 334741
Bolt × 1
# 334792
Fork; 1-2 Shift × 1
# 334841
Fork; 3-4 Shift × 1
# 334843
Fork; 5th Shift × 1
# 334845
Insert; Reverse × 2
# 334846-1
Snap Ring × 1
# 334860A
Speedometer Reluctor × 1
# 334997A
Output Sensor × 1
# 335439A
Plug; Sealing, small, 10.05mm OD × 1
# 359483
Insert; .770" Long, Straight × 2
# 411850-1
Bearing; Countershaft, Front, 45 ID X 20 W × 1
# 424260-2
Bearing Race; Countershaft, Front, 73.5 OD x 15.6 W × 1
# 424260-3
Plug; Rear Top Cover × 3
# 476484
Cup Race; Driven Transfer Gear to Case × 1
# D92280
Bearing; Transfer Gear × 1
# D92281
Needle Bearing × 1
# AT16792
Spacer; 5-78" OA × 1
# AT17138
Spring; 1-2 × 4
# AT17285
Vent Tube; 90 Degree × 1
# AT17988
Shift Rail; 3-4 × 1
# AT18320
Roll Pin × 8
# AT18437
Shift Lug × 1
# AT18863
Bushing; Shifter Bolt × 1
# AT18870
Detent Spring; Shift Rail, 2nd design, Green × 3
# AT20031
Detent Bullet × 2
# AT35660
Top Cover Vent Baffle × 1
# AT4500-63
Gasket × 1
# AT89279
Needle Bearing × 1
# ATC1110Q
Nut; Ouput × 1
# ATWT277-90