Transtar AftermarketManual Transmission

Part #: NV4500-GA

$2,392.22 $2,272.61

You save 5% ($119.61)

$1,500.00 Core

Add Vehicle for Fitment

Warranty Included

Description & Specs

All units are torn down and thoroughly cleaned. All hard parts are inspected and if a known failure point has been identified, the part is replaced with a remanufactured or new part that is OE-quality or better. All soft parts are replaced. Units are assembled and, when possible, Dyno tested (Software to test some late models units is not yet available).

Manual Transmission; Remanufactured; Cast Iron Case, Detachable Bell Housing, Internal Slave Cylinder, Square Four Bolt Shift Tower, Reverse Gear Is Synchronized, Uses A Nut To Hold The Rear Output Yoke On And Not A Bolt, Exhaust Hanger Bolts To The Passenger Side Of Transmis

Name	Specs
Country of Origin (Primary)	US
Minimum Order Quantity	1
Product Condition	Remanufactured

This Kit Contains

Gasket; PTO Cover × 1

# 301305

Loc. Pin × 1

# 301485

Bearing; Needle, 50mm x 58mm x 20mm × 1

# 303211A

Insert; Mode, Long, 45MM, Reverse Center × 1

# 321700-2A

Gasket; Adaptor to Transfer Case; Round with 6 Holes × 1

# 331304A

Small Parts Kit × 1

# 334001

Seal; Front × 1

# 334070

Seal × 1

# 334074A

Seal × 1

# 334074C

Seal × 1

# 334076

Seal × 1

# 334076A

Bearing × 1

# 334211-2

Bearing Cup × 1

# 334211-3

Needle Bearing; Input × 1

# 334240

Pocket Bearing, Input × 1

# 334267

Bearing Cap × 1

# 334483

3rd Gear Main Shaft, 29 Tooth, 5.61 Ratio × 1

# 334583A

Clutch Cone; Reverse Gear, For Mainshaft Reverse × 1

# 334587-2

Input Shaft; 22 Teeth, 10 Spline × 1

# 334670D

Cluster Shaft; Cluster, 35 Teeth Mainshaft Reverse × 1

# 334674A

Cone; Input Synchro × 1

# 334701-1A

1-2 Synchronizer × 1

# 334701-3

Synchro Ring; 3-4, 39 Teeth, 3.64" ID, Brass × 1

# 334703

Synchronizer; 5th × 1

# 334705

Key; For 1-2 × 1

# 334707-1

Key; 3-4 × 1

# 334707-3

Spring; 2-3 Synchro × 1

# 334710-3

Fork; 3-4 Shift × 1

# 334843

Insert; Reverse × 1

# 334846-1

Bearing; Countershaft, Front, 45 ID X 20 W × 1

# 424260-2

Bearing Race; Countershaft, Front, 73.5 OD x 15.6 W × 1

# 424260-3

Pinion/Input Bearing; 1.625" Bearing Inside Diameter; Rear × 1

# 742G255

Bearing Cup; Driven Transfer Gear to Case, Differential Pinion, 2.891" OD x .580" Cup Width × 1

# D92280

Bearing; Transfer Gear × 1

# D92281

Spring; 1-2 × 1

# AT17285

Race; Input Bearing × 1

# ATNP728109

+ See More

Vehicle Fitment

Years	Vehicle	Drive Types
2007 - 2007	Chevrolet Silverado 3500 Classic	RWD
2004 - 2006	Chevrolet Silverado 3500	RWD
2007 - 2007	Chevrolet Silverado 2500 HD Classic	RWD
2003 - 2006	Chevrolet Silverado 2500 HD	RWD
2007 - 2007	GMC Sierra 3500 Classic	RWD
2004 - 2006	GMC Sierra 3500	RWD
2007 - 2007	GMC Sierra 2500 HD Classic	RWD
2004 - 2006	GMC Sierra 2500 HD	RWD

+ See More