TranstarManual Transmission

Part #: NV4500-GA

$2,034.99 $1,500.00 Core

Description & Specs

All units are torn down and thoroughly cleaned. All hard parts are inspected and if a known failure point has been identified, the part is replaced with a remanufactured or new part that is OE-quality or better. All soft parts are replaced. Units are assembled and, when possible, Dyno tested (Software to test some late models units is not yet available).

Manual Transmission; Remanufactured; Cast Iron Case, Detachable Bell Housing, Internal Slave Cylinder, Square Four Bolt Shift Tower, Reverse Gear Is Synchronized, Uses A Nut To Hold The Rear Output Yoke On And Not A Bolt, Exhaust Hanger Bolts To The Passenger Side Of Transmission Case Behind PTO Cover, Main Case Cast 33903, Top Cover Cast 33893, Tail Housing Cast 25868

Name	Specs
Country of Origin (Primary)	US
Minimum Order Quantity	1
Product Condition	Remanufactured

This Kit Contains

Gasket; PTO Cover × 1

# 301305

Loc. Pin × 1

# 301485

Bearing; Needle, 50mm x 58mm x 20mm × 1

# 303211A

Insert; Mode, Long, 45MM, Reverse Center × 1

# 321700-2A

Gasket; Adaptor to Transfer Case; Round with 6 Holes × 1

# 331304A

Small Parts Kit × 1

# 334001

Seal; Front × 1

# 334070

Seal × 1

# 334074A

Seal × 1

# 334074C

Seal × 1

# 334076

Seal × 1

# 334076A

Bearing × 1

# 334211-2

Bearing Cup × 1

# 334211-3

Needle Bearing; Input × 1

# 334240

Pocket Bearing, Input × 1

# 334267

Bearing Cap × 1

# 334483

3rd Gear Main Shaft, 29 Tooth, 5.61 Ratio × 1

# 334583A

Clutch Cone; Reverse Gear, For Mainshaft Reverse × 1

# 334587-2

Input Shaft; 22 Teeth, 10 Spline × 1

# 334670D

Cluster Shaft; Cluster, 35 Teeth Mainshaft Reverse × 1

# 334674A

Cone; Input Synchro × 1

# 334701-1A

1-2 Synchronizer × 1

# 334701-3

Synchro Ring; 3-4, 39 Teeth, 3.64" ID, Brass × 1

# 334703

Synchronizer; 5th × 1

# 334705

Key; For 1-2 × 1

# 334707-1

Key; 3-4 × 1

# 334707-3

Spring; 2-3 Synchro × 1

# 334710-3

Fork; 3-4 Shift × 1

# 334843

Insert; Reverse × 1

# 334846-1

Bearing; Countershaft, Front, 45 ID X 20 W × 1

# 424260-2

Bearing Race; Countershaft, Front, 73.5 OD x 15.6 W × 1

# 424260-3

Pinion/Input Bearing; 1.625" Bearing Inside Diameter; Rear × 1

# 742G255

Cup Race; Driven Transfer Gear to Case × 1

# D92280

Bearing; Transfer Gear × 1

# D92281

Spring; 1-2 × 1

# AT17285

Race; Input Bearing × 1

# ATNP728109

+ See More

Vehicle Fitment

Years	Vehicle	Drive Types
2007 - 2007	Chevrolet Silverado 3500 Classic	RWD
2004 - 2006	Chevrolet Silverado 3500	RWD
2007 - 2007	Chevrolet Silverado 2500 HD Classic	RWD
2003 - 2006	Chevrolet Silverado 2500 HD	RWD
2004 - 2004	Chevrolet Silverado 2500	RWD
2007 - 2007	GMC Sierra 3500 Classic	RWD
2004 - 2006	GMC Sierra 3500	RWD
2007 - 2007	GMC Sierra 2500 HD Classic	RWD
2004 - 2006	GMC Sierra 2500 HD	RWD
2004 - 2004	GMC Sierra 2500	RWD

+ See More