Tools

Servo Capsule Remover, Slide Hammer Required

Linkage Repair Clip (Chrysler, Jeep) (Shift Cable Repair)

Harness Repair Kit, Red, Package of 5, Clips Harness Connector Into Solenoid

Linkage Pin Remover

Servo Capsule Driver/Installer, Installs The Capsule To The Correct Depth

Cooler Line Flusher Block for 6L80 and 6L90 Transmission lines The block is a dual fit tool. On one side it is bult for the Early 6L80 and 6L90 Transmission that have the combined line fixture. Roll 90 degrees and you are ready for the 6L80 transmission with the bypass block.

GM - Allison Cooler Line Fitting EARLY 5/8" Line (short tip) to LATE Model Bellhousing (7/8" threads) LINE TYPE This fitting is for the early 5/8 inch line with a 7/8 inch flange. That line is mainly found in '01, '02 and some '03 applications. The quick way to check the flange size is to use a box end 13/16 inch wrench... if it goes over the flange, then it is NOT the early line and this fitting will NOT work for your vehicle. BELLHOUSING TYPE Fits: GM Allison transmissions with the Late bellhousing with 7/8 -14 inch threads. These are found mainly in '03 -up vehicles but sometimes found in earlier models when a replacement bellhousing was needed to replace a broken bellhousing

PRNDL Pin Remover

Cooler Line Flusher Adapter, 6F35/6F50 Applications with Thermal Bypass Valve

Converts a Late Case to an Early Case